Which is NOT a method of controlled flooding in irrigation methods?
Anonymous Quiz
47%
(a) Contour
28%
(b) Ring basin
11%
(c) Check basin
14%
(d) Border strip
Blaney-Criddle equation used for calculating evapotranspiration is ideal, if and only when the following data set is available for a site.
Anonymous Quiz
21%
(a) Air-temperature
48%
(b) Air-humidity
14%
(c) Wind-wave
17%
(d) Type of soil
Lining of irrigation channels:
Anonymous Quiz
17%
(a) Increases the water logging area
69%
(b) Decreases the water logging area
10%
(c) Does not change the water logging area
4%
(d)None of the above
👍1
Water distribution systems are sized to meet the:
Anonymous Quiz
10%
(a) maximum hourly demand
6%
(b) average hourly demand
72%
(c) maximum daily demand and fire demand
11%
(d) average daily demand and fire demand
❤1
The peak factor suggested by CPHEEO for computing carrying capacity in the design of sewers for the contributory population of 20,0000 is
Anonymous Quiz
22%
(a) 2.00
37%
(b) 2.25
26%
(c) 2.50
15%
(d) 3.00
As per Indian Standard Specifications, the peak discharge for domestic purposes per capita per minute, is taken
Anonymous Quiz
14%
(a) 1.80 liters for 5 to 10 users
9%
(b) 1.20 liters for 15 users
23%
(c) 1.35 liters for 20 users
54%
(d) All options are correct
👍2
Critical dissolved oxygen (D.O) deficit occurs in which one of the following zones of pollution of 'oxygen sag curve' in case of self-purification of natural streams?
Anonymous Quiz
8%
(a) Zone of recovery
73%
(b) Zone of active decomposition
16%
(c) Zone of degradation
3%
(d) Zone of clear water
In which condition a doubly reinforced beam is used?
Anonymous Quiz
2%
(a) when extra safety is needed
80%
(b) when depth and breadth of beam have to be restricted in size
10%
(c) when a large moment is expected
7%
(d) when depth is more than 1 m
When a beam section spans over several supports continuously then the beam at supports should be designed as :
Anonymous Quiz
29%
(a) Simply reinforced beam
18%
(b) Prestressed beam
46%
(c)Doubly reinforced beam
6%
(d) Pre-cast beam
According to ISI recommendations, the maximum depth of the stress block for the balanced section of a beam of effective depth 'd' is :
Anonymous Quiz
49%
(a) 0.43 d
23%
(b) 0.55 d
12%
(c) 0.68 d
15%
(d) 0.85 d
Which precipitation is caused by the natural rising of warmer lighter air in colder and denser surroundings?
Anonymous Quiz
16%
(a) Cyclonic precipitation
29%
(b) Orographic precipitation
53%
(c) Convective precipitation
3%
(d) None of these
❤1
The hydrograph of short duration can be converted into hydrographs of longer duration by:
Anonymous Quiz
20%
(a) unit hydrograph
33%
(b) synthetic unit hydrograph
44%
(c) s-curve method
3%
(d) flood routing
Evaporation is measured using:
Anonymous Quiz
9%
(a) Rain gauge
37%
(b) An open pan
43%
(c) Lysimeter
9%
(d) Infiltrometer
2%
(e) Neutron tube
❤1
Media is too big
VIEW IN TELEGRAM
GPSC દ્વારા લેવાતી Civil Engineering ની પરીક્ષાઓની તૈયારી માટે સમાધાન આવી રહ્યું છે બોવ જ જલ્દી..
🚸 WebSankul - Civil Engineering 🏗
🎓 GPSC Civil Engineering Aspirants માટે
કઈક નવું આવી રહ્યું છે...
👔 જોડાયેલા રહો વેબસંકુલ સાથે...
📞 Helpline Number : 72018 66333
🚸 WebSankul - Civil Engineering 🏗
🎓 GPSC Civil Engineering Aspirants માટે
કઈક નવું આવી રહ્યું છે...
👔 જોડાયેલા રહો વેબસંકુલ સાથે...
📞 Helpline Number : 72018 66333
👍3
Identify the correct expression among the following:
Anonymous Quiz
24%
(a) Young's modulus = Strain/Stress
50%
(b) Lateral strain = Poisson's ratio Longitudnal strain
10%
(c) Young's modulus = Strain x Stress
16%
(d) Lateral strain = Poisson's ratio / Longitudinal strain
Total Number of elastic constant and independent elastic constant for material are :
Anonymous Quiz
17%
(a) 5, 3
36%
(b) 4, 3
9%
(c) 4, 4
37%
(d) 4, 2
In a continuous bending moment diagram, the point where it changes the sign is called:
Anonymous Quiz
5%
(a) Point of inflection
67%
(b) Point of contraflexure
5%
(c) Point of virtual hinge
21%
(d) All of the above options
2%
(e) None of these options
The maximum shear stress across a circular section is
Anonymous Quiz
64%
(a) 4/3 *Average shear stress
26%
(b) 3/2* Average shear stress
6%
(c) 5/4* Average shear stress
4%
(d) 9/5*Average shear stress
👍1
The difference between the latest allowable time and earliest expected time of an event is known as
Anonymous Quiz
30%
(a) Float
8%
(b) Normal Deviate
34%
(c) Free Float
28%
(d) Slack